Welcome to Flightinfo.com

  • Register now and join the discussion
  • Friendliest aviation Ccmmunity on the web
  • Modern site for PC's, Phones, Tablets - no 3rd party apps required
  • Ask questions, help others, promote aviation
  • Share the passion for aviation
  • Invite everyone to Flightinfo.com and let's have fun

Carbon Cub Airplane Tire Jack

Welcome to Flightinfo.com

  • Register now and join the discussion
  • Modern secure site, no 3rd party apps required
  • Invite your friends
  • Share the passion of aviation
  • Friendliest aviation community on the web

Sntry

Member
Joined
Sep 10, 2023
Posts
14
Hello All.

I do not have access to a ceiling lifting system (ceiling winch) to raise the airplane to install tires - 31 inch Bush. Seeking your recommendations and suggestions!

My initial attempt was using two - Powerbuilt 2 Ton UniJack Combination Hydraulic Bottle Jack / Jackstand in 1 Unit with one jack on each gear. Unfortunately, when I tried to place the tire, the jack was too close and had to move the jack inboard to the outer edge of the support making the installation a bit uncomfortable as the jack support bracket was on the very edge of the gear. Then, I used a combination of bottle jacks and floor jack but it was still really tight against the tire and at the edge of the gear frame. I don't need to reinvent this and simply need a safer and better method.

Would great appreciate your thoughts and suggestions. Jaime

IMG_4632.jpeg
 
I would not jack both wheels at the same time The aircraft will be less stable than with one main wheel on the ground.

I use a small hydraulic bottle jack with a small pad made from two layers of plywood. The lower layer has a hole to locate it on the jack ram. The pad has to be positioned so the contact point is exactly centered over the jack and first use leaves an indentation for future reference. The pad protects the landing gear finish and provides positive location of the jack on the landing gear clevis plate (inboard end of the axle).

If I remove the wheel I put a padded jack stand under the axle.

This works well for my 26 inch ABW. Others with much larger tires have bridged the two mean gear axles with steel angle iron and jacked that bridge near one end to get tire clearance for the jack.
 
Thanks, it was the initial install - as you can see the bottle jack seemed to be the perfect tool until the 31 ABW contacted the jack and not fully seated. I had to scramble to move the jack inboard until I could get the wheel on. Ultimately, the jack with a pad was as far inboard as possible and just under where the mount for the Acme shocks. It didn’t seem to stable. Unfortunately, I didn’t take a picture…. I am hoping someone will larger wheels has a better solution to this issue…
 
After extensive search, I found this as a possible option but waiting to hear from the vendor if it’s compatible with Carbon Cub and they are still selling…
 

Attachments

  • IMG_3819.jpeg
    IMG_3819.jpeg
    635.1 KB · Views: 0
On line sources indicate that the 31 inch ABW is only one inch wider than the 26 inch ABW (13 vs 12 inch). If that is true I would see no issue jacking the 31 inch ABW with the small jack that I use. I'd just need some spacers under the jack.

IMGP0962_edited-2.jpg


IMGP0964_edited-1.jpg
 

Latest resources

Back
Top Bottom