Those Crazy Sweedish Dash Drivers! (gear collapse)

[lineflyer1]

No problem. Do what you need to do to make the landing as safe as you can. Thanks for the discussion. The class I am in is quite boring, and I needed the debate!

:nuts:

Debate and discussion are good. Sometimes we can actually learn from different perspectives.

To criticize another crews actions having never flown the aircraft is something I try to avoid. There are way too many variables in an abnormal situation and way too many different systems setups.

In all circumstances one needs to reflect on whether we are adding to a safe outcome or injecting more variables into the game.

I have come to the belief that if something breaks in flight and the aircraft can be safely flown, don't try to be a hero and fix it while flying. Let maintenance look at it on the ground. Especially flight controls, ie. stab trim, flaps, spoilers, ailerons, yaw dampners. You may just may your problems worse.

Oh yea, and electrical problems!

 

[LR25]

What I am talking about has nothing to do with the QRH.

Not my words, but yours.

Heres the problem with your way of thinking.

If you bend up an airplane, because you decided that you were going to depart from the QRH, or go outside the aircrafts capabilities becuase of "your" precieved tecnique seemed to be the best solution, you will most likely never fly for a 121 operation again. And with your hell bent attitude on what you think is right wrong, you may not even hold a commercial license after the full review. But thats only if everything you did resulted in a costly (dollar amount) amount of damage, or if you killed, or maimed people becuase of something you could have prevented by following proven precedures, this is a worst case senario.

Best case is, everything worked out, and you become the hero, you follow what I'm getting at?

All were talking about here, is a gear problem that may or may have been fualty.

But, the simple fact remains, whether you are a DASH expert or not, if you only have AC powered pumps, which will be lost with no motors running, no rudder because the pumps are not running, who is going to deadstick the DASH in this case? And if you did, and the end result was the exact same that did happen to them, they wont even be able to fly rubber dog sh!t to Hong Kong......can we both aggree on that? Please say yes.

I do believe that we will all be well versed in DHC-8 hydrualics by the time this is all through, so if we can all learn something from this, I guess its worth the time to debate.

 

[atrdriver]

All aircraft certified under Part 25 must meet the same conditions. While performance may be different, all aircraft fly the same. The same overall technique and airmenship must be used to pilot them. Refer to the AIM and FAA AFH.

This is an emergency. The airframe will most likely be totaled if it doesn't need major repairs. People were injured as a result of this crews decision to use poor technique.

They may have no manual reversion, but they require a standby system. If the primary is mechanical, then there must be an electical hydraulic system or a manual reversion. An electic backup hydraulic system can pressurize any hydraulic system for more than enough time to stop an aircraft IF the gear does not collapse as expected.

And again, you show that you don't know what you are talking about. For example, on an ATR if you feather the props you lose all hydraulics if the gear handle is not in the down position. If you are attempting a belly landing where is the gear handle going to be? Yes, this is an emergency. Why on earth would you intentionally make a bad situation worse by failing both engines? Sorry, that just doesn't add up.

 

[Captzaahlie]

Might I suggest "Crow?"

Crow or maybe another bullsh1t sandwhich perhaps?

Sig, Wsurf stop it my sides are hurting from the laughter! I owe you guys a cold one next time we get stuck on an overnight together.......
Keep up the good work! I'll try to get a link to all the dash 8 systems here for ruskie so he can redesign the airplane for DeHavilland........ wish i had time to do it now!

 

[The_Russian]

My point is that the systems have absolutely nothing to do with the technique. Everyone is so obsessed with the QRH and systems that they don't see the point. This is basic stuff folks. Secure the engines prior to impact, touch down smooth, and hold the bad side up as long as possible.

 

[Singlecoil]

My point is that the systems have absolutely nothing to do with the technique. Everyone is so obsessed with the QRH and systems that they don't see the point. This is basic stuff folks. Secure the engines prior to impact, touch down smooth, and hold the bad side up as long as possible.

...and if the gear doesn't collapse, now all you have to control the plane is the rudder in the standby mode and the emergency brake handle with no antiskid. You'll probably blow a tire since you've never once used the emergency brake and don't know how hard to pull it.

The probable cause of that NTSB report would read:
The failure of all four main landing gear tires due to skidding/friction with the runway surface.
Related factor: The deactivation of all hydraulic systems including antiskid and normal braking by the pilot in command.

I get it now. You are either a flamebaiter or one of "those that will" out of the "those that have and those that will" equation.

 

[Flooder305]

I'm going to say a prayer tonight. One that I never work at the same place as The Russian, Two that I or my family or anyone I care about at all never fly with anyone as arrogant and incompetent as she appears here, and three that God give her a good wake-up call somehow before she ends up playing hero in the graveyard.

God save the future of American aviation if we're issuing pilot certificates to someone like this.

 

[The_Russian]

...and if the gear doesn't collapse, now all you have to control the plane is the rudder in the standby mode and the emergency brake handle with no antiskid. You'll probably blow a tire since you've never once used the emergency brake and don't know how hard to pull it.

With proper planning you can perform the landing with ease. You forgot to add aerodynamic braking in there, homey. I think I can figure out how to use it just fine.

The probable cause of that NTSB report would read:
The failure of all four main landing gear tires due to skidding/friction with the runway surface.
Related factor: The deactivation of all hydraulic systems including antiskid and normal braking by the pilot in command.

What NTSB report? For blown tires? Give me a break! Read NTSB 830, please.

I get it now. You are either a flamebaiter or one of "those that will" out of the "those that have and those that will" equation.

Wrong. Get off the bandwagon and start using your head. Read my posts, do not re-interpret what I say.

 

[The_Russian]

I'm going to say a prayer tonight. One that I never work at the same place as The Russian, Two that I or my family or anyone I care about at all never fly with anyone as arrogant and incompetent as she appears here, and three that God give her a good wake-up call somehow before she ends up playing hero in the graveyard.

God save the future of American aviation if we're issuing pilot certificates to someone like this.

Thanks for this completely unprofessional post. You obviously haven't the slightest idea of what I am talking about. No one is being a cowboy here, we are talking safety.

 

[atrdriver]

With proper planning you can perform the landing with ease. You forgot to add aerodynamic braking in there, homey. I think I can figure out how to use it just fine.

I seem to remember a 737 a few years ago that tried to use aero braking (against procedures) and ran off the end of the runway. Aero braking is fine for an F-15, not so much for a 121 aircraft. Also, I don't think that you have any idea how much braking you get from having those props flat, which of course you would lose in your scenerio.